Categories
Uncategorized

CCNA, CCNP, and Cisco Security Practice Exam Questions – OSPF Stub Areas, Switches, and More!

To help you prepare for total success on your Cisco certification exams, here are some complimentary practice exam questions. Answers are posted at the end of the article. Enjoy!

CCNA Certification And CCENT Certification:

A Cisco switch can take one of three actions with an incoming frame. Name all three and describe under what conditions each action would occur.

CCNA Security Certification / CCNP ISCW Exam:

What is SDEE, and what do we use it for?

CCNP Certification / BSCI Exam:

OSPF Total Stub areas can contain which of the following OSPF route types?

A. O
B. O IA
C. O* IA
D. O N1
E. O N2

CCNP Certification / BCMSN Exam:

What command will allow a Cisco switch to accept only secure remote connections? Where should this command be placed?

CCNP / ONT Exam:

What’s the difference between the two options shown below by IOS Help? What is the purpose of each?

R1(config)#int s0/0
R1(config-if)#auto ?
discovery Configure Auto Discovery
qos Configure AutoQoS

Here are the answers!

CCNA / CCENT Answer: If the switch’s MAC table has no entry for the destination MAC address of the frame, the frame will be flooded – that is, a copy of the frame is sent out every single port except the one it came in on.

If the switch’s MAC table does have an entry for the destination MAC address, and the source and destination are shown to be off different ports on the switch, the frame is unicast – sent out only the port leading to the destination address.

If the switch’s MAC table has an entry for the destination MAC, and the source and destination are shown to be off the same port, the frame is filtered by the switch – it’s not forwarded in any way.

Leave a Reply

Your email address will not be published. Required fields are marked *